Teak board 40mm finger-jointed (cut)

385,00  per m²

Made to measure, therefore excluded from revocation.

193 stock

Area (m²)
Price per piece
Estimated delivery by: Friday September 30nd

The cuttings of the teak panels are made from finger-jointed solid wood lamellas with a thickness of 40mm. The slats are glued waterproof, the surface is sanded smooth.

Quality A / B
Size 40 mm
Length 5cm to 240cm
Width 4cm to 100cm
dimensional tolerance +/-2mm in length and width
also in standard sizes available
Species Teak (Tectona grandis)
Surface sanded smooth
slats Solid wood finger-jointed
drying technically dried
Brand BioMaderas
Certificate FSC teak panels

The length is equal to the direction of the wooden slats. We ship for free wood pattern.

Processing instructions for solid wood panels

The solid lamellas for our solid wood panels are carefully selected and technically dried. They are glued together so that sapwood occurs mainly on the B side. Wood cores are therefore not glued alternately to wood cores. If the room climate is even and not too dry, possible changes will remain small. We would like to give you a few important tips on handling solid wood pallets. So that you enjoy working with the natural material wood just as much as we do!

Wooden top teak
Teak bathroom shelf

Usage

Solid wood panels are a natural product. Our panels are sorted during production according to strict quality specifications. The special wood structure and the natural play of colors give each panel an individual character. They do not constitute a reason for complaint.

1. Acclimatization

The wooden panels must acclimatize for at least 48 hours in the room in which they are to be installed. To do this, lay the panel flat and open the protective film. Protect the wooden panels from extreme changes in temperature and humidity. If the plate deforms, it must be turned over so that acclimatization can take place evenly on both sides. Bearing ledges and, if necessary, weighing down the plate with a weight are also helpful.

Teak washbasin 40mm
Worktop raw oiled

2. Surface treatment

A surface treatment (e.g. oiling) must always be carried out to the same extent on both sides. We recommend that BioMaderas Furniture oil for our solid wood panels. Alternative surface treatment materials are commercially available.

3. preparation

Pre-drill holes for the necessary screws to reduce stress. Screws should be screwed at least 15 mm deep into the solid wood panel. However, please note that this is a product made of solid wood, which swells and shrinks with fluctuations in humidity.

teak tree
Teak tree bark vanity

4. Assembly

Additional stabilizing strips should be attached to the underside to prevent deformation of the panel. Solid wood is a living material that expands and contracts with changes in temperature and humidity. A sufficiently wide expansion gap should therefore always be left open against all other non-living materials such as stone, steel, walls and pipes. It is best to cover this with a decorative strip. After years of intensive use, the solid wood panel may show stains, scratches and streaks. To refresh, sand lightly with a grinder or fine sandpaper and re-oil if necessary. In this way, minor damage can also be treated.

Shipping rate

Weight 32 kg
Product Type

, , ,

Species

wooden slats

finger-jointed slats

Origin

Size

Size

Certificate

Surface

Quality

, ,

1 review for Teak board 40mm finger-jointed (cut)

  1. Thomas Graf (via Google) -

    The handling is very good. Shipping and packaging top notch.
    Can be recommended unreservedly!

Add your rating

Share cart